User Manual
Cabinet Mounting Method (cont.)
• Attach Template 1 to rear of cabinet
and align arrow with hole center line
on Template 2. (Fig. 11)
FIG. 11
• Position remaining piece of
Template 2 under the cabinet and
align the hole center lines with arrows
on Template 1 so that the distance
from right hole center to left hole
center measure the distance indicated
on the template. (You may have to cut
excess paper from the middle of
template to make it lay flat.)
• Position Template 2. (The cut line
along the front edge of template must
be placed against the back of the front
rail. (Fig. 12)
FIG. 12
Drilling the Mounting Holes
While drilling, it is recommended that
safety glasses be worn to prevent
possible eye damage from cabinet
shavings.
1. Use a center punch or nail to make
an indentation for centering the drill
bit.
2. Drill through Template 2 at the four
black drilling holes indicated on the
template. (Drill should be held straight
to ensure proper alignment of bolts.)
3. After drilling the four holes, remove
the template and clean the drilled
holes.
***Important***
Selecting Your Mounting Bolts
1. You should have three sets of bolts
of varying lengths in the installation
package. Select on bolt of each size.
2. Hold each bolt against the cabinet
front rail. Pick the bolt that extends
beyond top of the bottom shelf by
3
/
16
"
(4 mm) to ¾" (19 mm). This will be
the bolt length needed for your
cabinets. (Fig. 13)
FIG. 13
Note: It is important to pick the
correct bolt length needed for your
cabinets. If the bolt is too short, it
won't reach the oven. If the bolt is too
long, it will not permit oven to be
drawn up to cabinet snugly and might
damage the microwave oven.
3. From inside the cabinet, insert the
bolts through mounting straps and
then into the drilled holes.
Attaching the Rear Brackets
For models with no rear brackets skip
to Mounting the Oven.
1. Remove the two top case screws on
the back of the oven. (See Template/
Rear Bracket Reference Guide.)
2. Select the two rear brackets for the
model you have and then secure to
the oven back with the two top case
screws. Make sure that the flat top
surface of the rear brackets are level
and flush with the top surface of the
oven case. (Fig. 14)
FIG. 14
Mounting the Oven
To aid installation, we suggest that you
use some solid support such as books
to hold the oven while you are
securing it with the mounting bolts.
(Fig. 15)
FIG. 15
Make sure that whatever you use is
stacked or cut as close as possible to
the height needed for oven to reach
the cabinet bottom.
1. Place the oven on the support and
move into position. Lift oven, aligning
the mounting holes on the oven with
the bolts. Do not grip the door handle
to help lift the oven.
2. Insert bolts into mounting holes on
the oven. Tighten the bolts to secure
oven to the bottom of the cabinet.
(Alternate between bolts so that oven is
drawn up evenly.)
3. Once oven is securely in place, plug
power cord into three prong
(grounded) wall receptacle.
3/16” - 3/4”
(4 - 19 mm)
TOP OF BOTTOM SHELF
5