Installation Guide
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com
1 - 8 8 8 - 6 9 - 4 3 - 5 3 3
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. The GE brand and logo are trademarks of the General Electric Company.
© 2013 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory
conditions.
RAIL251- R130816
Installation Instructions
RG6 Pixelated LED Signals – 12’’ (300mm) – Railway Grade Crossing
(Impact Test Resistance Lenses)
Operating Specifications:
Nominal Input Voltage:
10 V AC/DC
Voltage Range:
8 to 14 V AC/DC
Nominal Power Consumption:
8.4W (DC)
10.7W (AC)
Always use a sun shielding apparatus such as a visor or hood over the signals.
Do not attempt to open the LED module. No assembly is required.
Performance and behavior of the lamp (including sidelights) is guaranteed only when operated in the voltage
range stated above.
Testing:
When testing the lamp before installation, first check the electrical characteristics on the label on the back of the lamp
(see box “B” below) to avoid damaging the lamp.
Installation Steps:
NOTE: Failure to properly follow these instructions may cause signal to malfunction.
1. Remove the incandescent bulb, reflector and lens assembly from the housing.
2. Feed wires of the LED signal module through the conduit in the housing.
3. Insert the LED signal into the lens slot and rotate it until the arrow on the back of the module (A) is aligned with
the top of the housing.
4. Lock the LED signal module in place by tightening metal tabs over the rim of the module, or fastening a ring
holder over the module, as applicable.
5. Connect the wires to the AAR terminals.
This product is intended solely for the use of rail signaling and is not intended for use in any other applications
(B)
(A)
Check label for required
voltage
Ensure arrow ‘’’’ points
upward for proper beam
alignment
Risk of Electric Shock
Install unit in enclosure tested
to be suitable for wet locations
only.
Visor / Hood
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Prepare Electrical Wiring
Electrical Requirements
Do not use in wet locations
Follow all National Electric Codes
(NEC) and local codes.
WARNING / AVERTISSEMENT
Risk of Electric Shock. Disconnect Before Servicing or installing product.
Risque de choc électrique. Couper l’alimentation avant le dépannage ou avant
l’installation du produit.