Specification Sheet

ManualsBrandsGE ManualsHazardous LocationGE MGA

INDOOR LIGHTING

Guide Form Specifications – 2011

Lighting Solutions

GUIDE FORM SPECIFICATIONS

GENERAL DESCRIPTION

MINI•GARD

FLUORESCENT LUMINAIRE

ENCLOSED AND GASKETED

The complete luminaire designated ________ (identify) shall

be a GE MINI.GARD

fluorescent luminaire, ordering number

________ (specify MGA, plus ordering number logic from cata-

log or approved equal, to operate ________ (specify one [13

or 26] watt or two 26-watt fluorescent) lamp(s) from a nominal

________ (specify 120, 277, or 347) volt, 60 Hertz power source

and shall be capable of starting and operating the specified

lamp within the limits specified by the lamp manufacturer. The

luminaire shall contain a

completely prewired integral ballast and optical assembly suit-

able for continuous service, either indoors or outdoors, in an

ambient temperature of 40 degrees C. Standard construction

is IP55. The luminaire shall be UL Listed SUITABLE FOR WET

LOCATIONS and UL Listed to Canadian National Standards and

Codes for Indoor/ Outdoor Locations.

The optical assembly shall include a ________ (specify large

glass globe with or without Maxi-Lux

guard). The optical as-

sembly shall also include as an accessory ________ (specify no

reflector or dome, deep dome or angle dome reflector).

External reflectors shall be aluminum with a chemically bonded

lightweight non-breakable ALGLAS

finish on inside and outside

surfaces for corrosion resistance.

The Maxi-Lux guard shall be of inverted design for improved

photometric performance.

The optical assembly shall contain a compact double biaxial

socket for fluorescent lamps. The 52-watt fluorescent unit shall

have provision for two 26-watt lamps. The optical assembly

shall be charcoal filtered.

OPTICAL ASSEMBLY

* FOR MORE DEFINITIVE INFORMATION, REFER TO BALLAST

SPECIFICATIONS IN TECHNICAL DATA

SECTION.

MECHANICAL CONSTRUCTION

For ease of installation and to facilitate maintenance and re-

placement, the MGA luminaire shall be supplied as components

- ballast, mounting, optical and accessories. A lamp shall be

included but shall not be installed.

The luminaire shall include a die-cast low copper aluminum

housing with electro-epoxidized gray paint finish inside and

outside. All external hardware shall be stainless steel. There

shall be provision for a ballast safety chain.

The luminaire shall be ________ (specify ceiling, flexible pen-

dant, angle stanchion, pendant, straight stanchion or wall)

mounted. A stainless steel closure screw in the ballast housing

shall mate with a polymer coated insert in the mounting com-

ponent.

BALLAST OPERATION

The luminaire shall contain a standard ________ (specify HPF

Reactor or NPF Reactor) type ballast* in full compliance with

lamp-ballast specifications available to the fixture manufac-

turer from the lamp

manufacturers at the time of fixture manufacture.

The ballast shall reliably start and operate the lamp in

ambient temperatures down to - 32°F.

Summary of content (2 pages)

PAGE 1
g INDOOR LIGHTING GE Lighting Solutions GUIDE FORM SPECIFICATIONS Mini•Gard TM FLUORESCENT luminaire ENCLOSED AND GASKETED GENERAL DESCRIPTION The complete luminaire designated ________ (identify) shall be a GE MINI.
PAGE 2
g GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com 1-88 8 - 6 9 - 4 3-5 3 3 GE Lighting Solutions is a subsidiary of the General Electric Company. Evolve and other trademarks belong to GE Lighting Solutions. The GE brand and logo are trademarks of the General Electric Company. © 2011 GE Lighting Solutions. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.