Installation guide

ManualsBrandsGE ManualsDishwasherOfficial GE dishwasher

Dishwasher Installation

DISHWASHER WET TEST

• Turn on power supply or plug power cord into outlet,

if equipped.

• Select a cycle to run and push the START button.

• Ensure the door is latched. Dishwasher should start.

• Check to be sure that water enters the dishwasher.

If water does not enter the dishwasher, check to be

sure that water and power are turned on.

• Check for leaks under the dishwasher. If a leak

is found, turn off power at the breaker, and then

tighten water connections. Restore power after leak

is corrected.

• Check for leaks around the door. A leak around

the door could be caused by door rubbing or

hitting against adjacent cabinets. Reposition the

dishwasher if necessary. See Step 13.

• Press and hold the START button for 3 seconds to

cancel the cycle. The unit will begin to drain. Check

drain lines. If leaks are found, turn off power at the

breaker and correct plumbing as necessary. Restore

power after corrections are made. See Steps 7, 8, 9,

10 and 17.

• Open dishwasher door and make sure all of the

water has drained. If not, check that disposer plug

has been removed and/or air gap is not plugged.

Also check drain hose to be sure it is not kinked

underneath or behind dishwasher. See Step 17.

• Press START button once again and run dishwasher

through another cycle. Check for leaks and correct if

required.

• Repeat these steps as necessary.

REPLACE FLOOR

PROTECT PAN

(on some models)

• Slide the floor protect pan under the dishwasher

until its side lock slots are close to engaging the side

mounting tabs on the dishwasher.

• Lift the pan until its lock slots contact the mounting

tabs and push the pan back to engage them.

• When properly installed, the top of the lock slots will

be over the mounting tabs.

• Connect the leak sensor connector to the leak sensor

(on some models).

Floor Protect

Pan

Figure AE

Floor Protect

Pan

Front

Rear

Mounting Tab

Two on each side

of the dishwasher

Lock Slots

Two on each side of

the floor protect pan

Leak Sensor

(on some models)

Lock Slot

Mounting

Tab

STEP 20 STEP 21