Specification

PEB9159EJES
GE Profile
™
Series 1.5 Cu. Ft. Countertop Convection/Microwave Oven
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
For answers to your Monogram, GE Café
™
Series, GE Profile
™
Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
®
Service, 800.626.2000.
Specification Revised 3/16
Listed by
Underwriters
Laboratories
OPTIONAL ACCESSORY TRIM KITS FOR GE MICROWAVE
OVENS (AVAILABLE AT ADDITIONAL COST)
For a custom built-in appearance, these kits allow built-in installation
of the countertop microwave oven into a wall or cabinet alone and are
U.L. approved for installation over a GE single electric wall oven.
These kits should not be installed over a gas wall oven.
NOTE: 120V, 60-cycle, grounded power receptacle location optional
on back within cabinet opening.
INSTALLATION INFORMATION: This information is not intended
to be used for installing unit described. Before installing, consult
installation instructions packed with product/kit for current
dimensional data.
ACCESSORY
TRIM KITS "Z"
MAX
HEIGHT
TRIM
KITS
30" Deluxe 29-3/4" 19-1/8" JX9153EJ
27" Deluxe 26-7/8" 19-1/8" JX9152EJ
CABINET OVERLAP REQUIREMENTS 30" 27"
A - Overlap of trim kit over top of cabinet 1" 1"
B - Overlap of trim kit over bottom of cabinet 1" 1"
C - Overlap of trim kit over sides of cabinet 3-5/16" 1-7/8"
NOTE:
Allow an additional inch
of clearance beyond trim
frame on all sides.
ACCESSORY TRIM KIT Z
JX9153 29-3/4"
JX9152 26-7/8"
19-1/8"
Allow 3"
clearance
*For ADA compliance, the microwave
must be installed no higher than 37".
A
C
23-1/8" ± 1/16"
Bracket
Trim
Kit
17-1/16" ± 1/16"
36" MIN.*
B
Z
18" MIN. receptacle
in cabinet 16" MIN.
receptacle outside
cabinet
CABINET OVERLAP REQUIREMENTS 30" 27"
A - Overlap of trim kit over top of cabinet 1" 1"
B - Overlap of trim kit over bottom of cabinet 1" 1"
C - Overlap of trim kit over sides of cabinet 3-5/16" 1-7/8"
NOTE: Allow an additional
inch of clearance beyond
trim frame on all sides.
EXTERIOR DIMENSIONS (IN INCHES)
Height 12-3/16"
Width 21-3/16"
Depth 16"
Depth including bumpout 20"
Depth from back of case to front legs 13"
Height
PRODUCT DIMENSIONS
Width
Depth
Depth including bumpout
Depth from back of case to front legs
12-3/16"
21-3/16"
16"
20"
13"
12-3/16"
21-3/16"
16"
13"
20"
Height
PRODUCT DIMENSIONS
Width
Depth
Depth including bumpout
Depth from back of case to front legs
12-3/16"
21-3/16"
16"
20"
13"
12-3/16"
21-3/16"
16"
13"
20"