Specification

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
PHP7036DT
GE Profile
™
36" Built-In Touch-Control Induction Cooktop
For answers to your Monogram, GE Café
™
, GE Profile
™
or GE Appliances
product questions, visit our website at geappliances.com or call
GE Answer Center
®
Service, 800.626.2000.
ADA
COMPLIANT
Listed by
Underwriters
Laboratories
Specification Revised 10/22
36"
1-3/4" MIN.
to rear wall
18-7/8"
33-3/4"
19-1/8" to
19-1/4"
33-7/8"
to 34"
2-1/2" MIN.
Required
Cooktop
To insure accuracy, it is best to make a
template when cutting the opening in the counter
20-1/2"
13" MAX. depth of unprotected
overhead cabinets
2" MIN. Clearance
from cutout to nearest
vertical wall or cabinet
on right side of the unit
below the 15" MIN.
clearance height.
15" MIN. height
from countertop
to nearest cabinet
(including light rails)
on both sides of
cooktop
30" MIN. Clearance from
countertop to unprotected
overhead surface
See label next
to nameplate for
MIN. clearance
to rear wall.
2" MIN. clearance
to side wall from cut-out
on the left of the unit
4-5/8" at baffle near center
of unit (except when installed
above an approved wall
oven) and 3-1/4" at rear
of air intake
IMPORTANT: Requires a 3" free area between
the bottom of the cooktop to any combustible
material, i.e., shelving. Free area not required
when installing wall oven underneath cooktop.
Refer to installation instructions. Requires a 15"
minimum from cooktop to adjacent overhead
cabinets. Units are furnished with a 48" flexible
armored cable.
NOTE: 36" induction cooktops are approved
for use over select GE 30" Single Wall Ovens
and Warming Drawers. Refer to cooktop
and wall oven/warming drawer installation
instructions packed with product for current
dimensional data. If installed with a GE
Telescopic Downdraft System, consult both
the cooktop and downdraft installation
instructions packed with product before
installing. Cooktop gas/electric supply may
need to be re-routed to install downdraft. The
countertop cutout requires 23-1/2" minimum
flat countertop surface and 25" minimum total
countertop depth. In addition, other clearances
to front edge of the countertop must be
considered.
Before installing, consult installation
instructions packed with product for
current dimensional data.
APPROXIMATE COOKING DIMENSIONS
KW R ATING
240V 11.6
208V 10.1
AMPERAGE
240V 50 Amps
†
208V 50 Amps
†
†
NOTE: Check local
codes for required
breaker size.
2-1/2" MIN
From front edge
of countertop to front
edge of cooktop cutout
31-1/4" MIN
From top surface
of countertop to
top surface of
wall oven support
platform
INSTALLATION ABOVE A WALL OVEN
INSTALLATION ABOVE A WALL OVEN