- General Electric Dishwasher Owner's manual

Options
The light above the pad will be ON to indicate which OPTION has been selected.
HI TEMP RINSE Turns on the heater in all prerinse and final rinse cycles to help prevent spotting on
dishware. This option may be turned ON or OFF during the wash cycle.
HI TEMP WASH Energizes the heater in all prewash fill cycles. Recommended for use with heavily
soiled dishes. Option may be turned ON or OFF during the wash cycle.
HEATED DRY Shuts off the drying heat options. Dishes air dry naturally and energy is saved. You
OFF can prop the door open after the light goes ON below the word CLEAN.
HEATED DRY Turns the heater on for fast drying. This cycle will extend the time to your wash
ON cycle by 30 minutes. NOTE: Cannot be selected with RINSE & HOLD cycle.
LOCK When the LOCK pad is touched twice within 3 seconds, all pads become inoperative.
You can lock the controls to prevent any selections from being made. Or you can lock
the controls after you have started a cycle or selected DELAY START so the cycle or
DELAY START is not interrupted.
Children cannot accidentally start dishwasher by touching pads with this
option selected.
To unlock the dishwasher after it has been locked, touch the LOCK pad twice
within three seconds. The light above the LOCK pad will be off.
DELAY START You can delay the start of a wash cycle for up to 8 hours. Press and hold the
DELAY START pad to choose the number of hours you want to delay the start
of the cycle. The machine will count down and start automatically at the correct
time. NOTE: If you forget to lock the door a reminder signal will beep until you
do so.
RESET To change a cycle after washing starts, touch the START/RESET pad to cancel
the cycle. After water is pumped out and motor stops, you can reprogram and
restart the dishwasher.
Customer ServiceTroubleshooting TipsOperating InstructionsSafety Information
Start
Close the door until it locks into place and touch the START/RESET pad to
begin the cycle. There is a time delay between start-up and water fill so you
will not hear any wash action right away.
The cycle is complete when the light is ON below the word CLEAN.
3
2
NOTE: The dishwasher remembers your last cycle so you don’t have to
reprogram each time. When the dishwasher is loaded and door latch is in the
locked position, the control panel lights will be
ON and display the last settings
you selected.
If you don’t want to change any of the settings, simply touch the START/RESET
pad to begin the cycle.
Also, if a power failure occurs, NORMAL and HEATED DRY ON will automatically be
programmed. Make any new selections and touch the
START/RESET pad to begin
the cycle.
9