Installation Guide

7
Flush Mount Installation Preparation (Monogram Only)
PREPARE THE INTERIOR
Cut and install side cleats:
• Cut side wood cleats to height of cabinet
opening and approx. 2-1/2” in depth. Install,
on each side, Dim. E from the front face of the
cabinet.
Cut and install bottom cleat:
• Cut bottom wood cleat to a height of 1-1/8”, a
depth of the cabinet minus Dim. E and a width
of 25-1/4” to fit between side cleats. Install
onto the cabinet floor between the side cleats,
push it all the way back against cabinet wall
and make sure its front face aligns with the front
faces of the side cleats (Dim. E gap from the
front cabinet face).
A Side and top cleats depth 2-1/2” min.
B Bottom cleat height 1-1/8”
C Bottom cleat depth Cabinet depth
minus Dim. E
D Bottom cleat width 25-1/4”
E All four cleats inset depth 1-1/4”
PREPARE THE OPENING
The Advantium 120 can be installed in
combination with other Built-In Appliances.
Always follow each product’s Installation
Instructions to complete the installation.
Single Advantium 120 Installation:
Cut the opening in a cabinet to the dimensions
shown.
• The support must be level and rigidly mounted,
flush with the bottom edge of the cutout.
TOP
VIEW
Front Face of Cabinet
EE
A A
C
D
IMPORTANT:
Always maintain 36-3/4” minimum height from the floor to the cutout in any single or
combined installation.
**18-7/8”
Construct
solid bottom
- Min. 3/8”
plywood
supported on
all four sides.
Must be able to
support weight
of oven and
contents.
36-3/4”
Min.
F *
23-1/2” min.
2” Min.
*See table
below for
desired reveals
on sides.
Per
appliance
specs.
Oven or
warming
drawer
Approved Flush Installation
Dimension F
1/8” Reveal 1/4” Reveal
Single Advantium 27” 27-
1
/4”
Over Warming Drawer 27” 27-
1
/4”
Over Oven 27” 27-
1
/4”
Over Oven and Warming Drawer 27” 27-
1
/4”
Over Built-in Speedcook Oven 27” 27-
1
/4”
Double Advantium (side by side) See page 8
Under Cooktop or Countertop See page 8
** Top and bottom reveals are set to
1
/8”.
E
C
B
D
A
A