Installation guide

Installation Preparation
PreparationWIT____HHan Accessory Storage Drawer
NOTE:MODELZSCI201 CAN ONLYBEINSTALLEDWITHAN ACCESSORYSTORAGEDRAWERIF INSTALLEDABOVE36-3/4".
MODELZSC1202CANNOTBEINSTALLEDWITH AN ACCESSORYSTORAGEDRAWER.SEEINSTALLATIONPREPARATIONWITHOUT
AN ACCESSORYSTORAGEDRAWERFORTHIS MODEL.
PREPARE THE OPENING (cont.}
The Advantium &20V can be installed in
combination with other GE/Monogram appliances.
Always follow each product's Installation
Instructions to complete the installation.
Single Advantium 120V Installation:
Order a 30" wide single oven cabinet or cut
the opening in a wall to the dimensions shown.
21"
25-1/4"_
4k-- Hin.
\\\
\
\\
Construct Bose
" Min. 3/8" Plywood
Supported by 2 x
4 or 2 x 2 Runners
all Four Sides
uired for
Monogram models
• Allow 2-1/8" case trim overlap on the sides,
1-1/16" overlap on the top and 7/8" overlap
on the bottom of the opening for all models.
• Oven overlaps will conceal cut edges on all sides
of the opening.
When installed over a single oven or a warming
drawer, allow at least 2" between the two
openings. This separation will provide clearance
for bottom overlap of the Advantium 120V and the
other appliance overlaps.
Construct a solid oven floor of 3/8" min. thick plywood
supported by 2 x 4 or 2 x 2 runners on all sides.
The support must be level and rigidly mounted,
flush with the bottom edge of the cutout.
PREPARE THE OPENING (cont.}
Installation over a GE/Monogram
Warming Drawer:
23-1/2"
Construct Solid
Bottom Min. 3/8"
/Plywood Supported
by2x4or2x2
Runners all Four
Sides
2" Min.
(3" Recommended)
Warming
Drawer
Requirement
*Required for
Monogram models
NOTE: Additional clearances between the cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth
and height. See Warming Drawer installation
instructions for details.
lO