Installation guide

ASSEMBLY TO ADVANTIUM BUILT-IN SPEEDCOOK OVEN
| REMOVE PACKAGING AND PARTS
• Remove the drewer from the certon.
• Remove ell pecking materiel end tope.
• Open the drewer end remove eny ports inside.
• Locete ports.
Assemblg
Instructions
Side Supports (2)
Assembly Instructions
Under-the-Counter
(UTC)Mounting Bracket
Screws Color-Matched
(6required, Screws
2 extra) (4 required,
i extra)
[_ UNDER-THE-COUNTER (UTC}
MOUNTING BRACKET INSTALLATION
NOTE: For UTC models PSB9120 end ZSC1201 only.
Open the occessory drower so you hove
occess to the top brocket.
Remove the three screws securing the top
brocket.
r_ Install the new UTC mounting brocket using
the screws removed previously.
r_ Close the drawer and proceed with the
installation.
[]
B]
ASSEMBLING THE OVEN TO DRAWER
Place storage drawer on a surface with
the front of drawer hanging over the edge
of the surface. Not placing the front edge
of drawer over the edge of the surface may
result in damage to the drewer since the front
edge of drower bongs below the bottom
of drower.
Place the oven on top of the storage drawer.
Hake sure that the back and sides of the oven
align with the back and sides of drawer.
NOTE: The bottom of the oven side flanges will
sit directly in front of the top of the storoge
drower side flonges.
18