Installation guide

Installation Preparation
Preparation WITHOUT an AccessoryStorage Drawer
PREPARE THE OPENING (cont.)
Installation over another GE/Monogram
Under-the-Counter IUTC) oven:
Construct Solid
Bottom Min.
]/8" Plywood
_ Supported by
2x4or2x2
Runners oil
Four Sides
2" Min.
(3" Recommended)
• If you are mounting on Under-the-Counter
GE/Honogram oven over another, use the
dimensions shown. The middle rail separating
the two openings may need to be larger than
the 2" minimum shown.
PREPARE THE OPENING (cont.)
Installation under a GE/Monogram
Microwave Oven and over a Warming
Drawer:
Per Oven
Recuirement
Construct Solid
Bottom Min.
]/8" Plywood
Supported by
/2x4or2x2
Runners all
Four Sides
Min.
4.5" Recommended
2" Hin.
(3" Recommended)
NOTE: Additional clearances between the cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer locution
do not obstruct the required interior depth
and height. See Warming Drawer installation
instructions for details.
ACAUTION: Forpersonal safety, the
mounting surface must be capable of supporting
the cabinet load, in addition to the added
weight of this approximate 80-pound oven, plus
additional oven loads of up to 50 pounds or o
total weight of 130 pounds.
APRECAUCION: Paraseguridod
personal, la superficie de montaje debe poder
soportor la cargo del gobinete, adem6s del peso
aproximado de 80 libras del homo, m6s los
cargos odicionoles del horno de hosto 50 libros
o un peso total de hosto 130 libros.