Installation guide

Pre-Test Checklist
Remove all protective film, if present,
and any stickers.
Check to be sure that all wiring is secure
and not pinched or in contact with
moving parts.
Check that the bottom trim is installed
properly (see page 11).
Check to be sure the mounting screws
are installed and flush with the side trim
(see page 10).
Operation Checklist
Remove all items from the inside
of the oven.
Check that conduit is securely
connected to the junction box.
Turn on the power to the oven. (Refer to
your Owner's Manual.) Verify that the
bake and broil units, and all cooking
functions operate properly.
Check that the circuit breaker is not
tripped nor the house fuse blown.
Seeyour Owner's Manual for
troubleshooting list.
NOTE TO ELECTRICIAN: The power
leads supplied with this appliance
are UL recognized for connections
to larger gauge household wiring.
The insulation of these leads is rated
at temperatures much higher than
the temperature rating of household
wiring. The current carrying capacity
of a conductor is governed by the wire
gauge and also the temperature rating
of the insulation around the wire.
NOTE: ALUMINUM WIRING
A.
B.
WARNING: IMPROPER
CONNECTION OF ALUMINUM HOUSE
WIRING TO THE COPPER LEADS CAN
RESULT INAN ELECTRICAL HAZARD
OR FIRE.
Splicecopper wiresto aluminum
wiringusing specialconnectors
designed and UL approved for
joiningcopper to aluminum,
and followthe manufacturer's
recommended connector
procedure closely.
NOTE: Wire used,locationand
enclosureofsplices,etc.,must
conform to good wiringpractice
and localcodes.
12