Installation guide

Installation Instructions
[] INSTALL DOWNDRAFT VENT
(_) Two stabilizing brackets must be installed on
each side of the downdraft vent.
, For right-side or straight-down blower
discharge, fasten the stabilizing brackets at
locations A, B, D and E.
. For left-side blower discharge, fasten the
stabilizing brackets at locations B,C, D and E.
D j
A_
C_
--E
-B
C
(_ Place the downdraft vent into the countertop
cutout so that the buck flange of the vent is
sitting on top of the countertop.
Note: The downdraft vent mug need to be
turned at an angle to fit into the countertop
cutout.
(_ Secure the screws for the stabilizing brackets to
the cabinet back and side walls.
Cabinet Back
Bracket
Downdraft Ve_t__ Location A
(_ Check that the downdraft vent is verticallg level.
Operate the vent 3 to 5 times to ensure proper
installation.
L_w i
..................
O Place Cooktop into the countertop cutout. There
should be a 1/8" minimum gap between the
front of the vent trim and the rear of the cooktop.
It mag be necessarg to readjust the cooktop and
repeat steps C and D.
[][] INSTALL DUCTWORK
,,The downdraft blower sgstem is designed for use
with 3-1/4" x 10" ductwork. It can be trunsitioned to
6" round.
• Ductwork MUST be vented to the outside-never
in a crawl space, attic or other enclosed space.
6" PVC duct should be used when installing under a
concrete slab.
NOTE: Local building code must be followed for
installation in specifging approved tgpe and schedule
of PVCduct used.
• DO NOT USE flexible plastic ducting.
• Alwmgs use appropriate roof or wall cap with dumper.
Luundrg-tgpe wall cups should never
be used.
,, Use the straightest duct run possible.
,, For satisfactorg performance, the duct run should
not exceed 100 ft. or its equivalent length when
bends or various fittings are used. Refer to the table
of equivalent lengths to calculate gour installation.
Install ductwork so the piece of duct nearest the
downdruft unit slots INTO the next piece of the duct.
Secure the joints with self-tapping screws and upplg
duct tape around the joints to ensure an airtight seal.
_Duct Tape
am and Screw
Air
11