Installation guide

Installation Preparation
VENTING OPTIONS
, The downdraft vent is shipped with the
discharge outlet pointing straight down
and can be changed to the left or right
side.
• The blower outlet is sized for 3-1/4" x 10"
and can be transitioned to 6" round.
• Order JXRB67 for installation of the
blower and motor below the floor.
Side-to-Side Adjustments:
The entire blower mounting plate can be
adjusted 3-1/2" to the left or right. This
will help to align vent discharge to house
ductwork.
Discharge Down
(As Supplied)
Loosen Screws
to Adjust
3-1/2" to
Left or Right
Discharge Down
(AsSupplied)
16-3/8"
Discharge Left
Discharge Right
Discharge Direction
The blower assemblg mag be removed and turned
90 ° for a left- or right-side discharge.
, A left or right 90 ° direction adjustment should be
performed before dropping into the countertop
opening.
, Flatten the shipping box to use as a pad.
, Lag the vent on its back and onto the pad.
To change to a left or right discharge:
, Remove the 4 screws holding the blower and the
mounting plate assemblg to the downdraft vent.
Retain screws.
, Remove blower assemblg; turn it over to access the
4 nuts holding the blower to the mounting plate.
Remove the nuts.
IMPORTANT: Do not lift motor bg the power cable.
, Turn the blower to the left or right discharge
direction and reinstall the 4 nuts.
, Reinstall blower and mounting plate with original
screws.
9