Installation guide

Installation Instructions
r_ ADAPTING BLOWER
FOR RECIRCULATION
NOTE:The exhaust adaptor with damper is not
needed for recirculating models. You may want
to save them for possible future use.
[_ Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
___ BlowerPlate
[_ Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
BEFORE:FanBlade
openings Facing Up ........ EndB
End A "_
[_ Roll the blower unit 90° so that fan blade openings
are facing out the back of the oven.
J-
Oven
AFTER:FanBlade
OpeningsFacing _ .....
Forward .......
....._ J _" Oven
NOTE: Make sure wires remain routed in the grooves
of the motor frame.
[_ Place the blower unit back into the opening.
_kWA RN!NG: Riskofelectricshock
can cause injury or death. Do not pull or stretch
the blower unit wiring. Hake sure the wired are
not pinched.
[_ Close the blower plate. Secure with the screw
removed earlier.
Blower Plate
Back of
Oven
Screw
2O