Installation guide

Installation Instructions

_ ALIGNING THE WALL PLATE

Hole

Draw a

Vertical Line

b---- on Wall from

Center of Top

Cabinet

Hole C

ACAUTION'.

Wear gloves to avoid cutting

fingers on sharp edges.

olo

4 T

AreaE J

[_ Draw a vertical line on the wall at the center of the 30"

wide space.

[_ Usethe mounting plate as the template for the rear wall.

Placethe mounting plate on the wall, making sure that

the tabs are touching the bottom of the cabinet or

the level line drawn in Step C for cabinets with front

overhang. Line up the notch and center line on

the mounting plate to the center line on the wall.

[_ While holding the mounting plate with one hand, draw

circles on the wall at holes A, B, C and D (see illustration

above/actual plate marked with arrows). Four holes

must be used for mounting.

NOTE: Holes Cand D are inside area E.If neither C nor D

is in a stud, find a stud somewhere in area Eand draw a

fifth circle to line up with the stud. It is important to use

at least one wood screw mounted firmly in a stud

to support the weight of the oven.

Set the mounting plate aside.

WA RNING:Riskofelectricshock.Cancause

injury or death. Take care to not drill into electrical wiring

inside walls or cabinets.

[_ Drill holes on the circles. If there is a stud, drill a sad'hole

for wood screws. For holes that don't line up with a stud,

drill a %" hole for toggle bolts.

NOTE:DO NOTMOUNTTHEPLATEAT THISTIME.