Installation guide

Installation Instructions
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws,
a hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
• Readthe instructions on the TOPCABINETTEMPLATE.
• Tape it underneath the top cabinet.
• Drillthe holes, following the instructions on the TOP
CABINETTEMPLATE.
At-^, i-rir, t,i
ui, : Weorsofetygoggleswhen
drilling holes in the cabinet bottom.
r_ ASSEMBLE AND INSTALL ADAPTOR
Da
Exhaust_q_-_
Adaptor" _ "'_C_-:
Front o'f_
Oven
Remove Screw
Topof Blower Plate
Tabs
_ Remove Screw from
Back of Blower Plate
¢ Back of Oven
_wer Plate
[_ Place the oven in its upright position, with the top
of the unit facing up and the front of the unit facing
toward you.
[_ Remove the screw on the back side of the blower
plate and raise the blower plate off of the microwave.
[_ Slide the damper from left to right into the tabs on the
blower plate. The yellow tape on the damper should
be facing you. If the blower plate is not raised off of
the top of the microwave, the damper cannot slide
into position.
[_ Remove the yellow tape from the damper. Make sure
that the damper pivots easily before mounting oven.
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
oven is installed.
_ MOUNT THE OVEN
CA UTI'0N:to t ,eriskofpersonal
injury (back injury or other injuries due to excessive
weight of the microwave) or property damage, you
will need two people to install this microwave.
IMPORTANT: Do not grip or use handle during
installation.
A WA RNING:RiskofElectricShock.
Can cause injury or death: If installing unit
with metal countertops, cover the edge of the
power supply cord hole with the power supply cord
bushing.
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening screws.
NOTE: When mounting
the microwave, thread
power cord through hole
in bottom of top cabinet.
Keep it tight throughout
Steps 1-3. Do not pinch
cord or lift oven by pulling
cord.
[_ Lift microwave, tilt it
forward, and hook slots
at back bottom edge
onto four lower tabs of
mounting plate.
[_ Rotate front of oven up
against cabinet bottom.
[_ Insert a self-aligning screw through top-center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (Itwill be completely
tightened later.)
13