Installation guide

Installation Instructions
_4-1 MOUNT THE OVEN
_L,_U/|Ui_: TO avoidthe risk ofpersonal
injury (back injury or other injuries due to excessive
weight of the microwave) or property damage, you
will need two people to install this microwave.
IMPORTANT: Do not grip or use handle during
installation,
A WARN !NG: RiskofElectricShock.
Can cause injury or death: If installing unit
with metal countertops, cover the edge of the
power supply cord hole with the power supply cord
bushing.
IMPORTANT:If filler blocks are not used, case damage
may occur from overtightening screws.
NOTE: When mounting
the microwave, thread
power cord through hole
in bottom of top cabinet.
Keep it tight throughout
Steps !-3. Do not pinch
cord or lift oven by pulling
cord.
[_ Lift microwave, tilt it
forward, and hook slots
at buck bottom edge
onto four lower tabs of
mounting plate.
[_ Rotate front of oven up
against cabinet bottom.
[_ Insert a self-aligning screw through top-center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.)
Cabinet Front
Cabinet Bottom Shelf
Filler Block
_kThis distance
TEquivaJent |can NOT
J to Depth |exceed 2"
[ of Cabinet |toensure
.[ Recess $ proper..
_ns_aua_lon
Oven Top
-- Self-Aligning Screw
[_ Insert 2 self-aligning screws
(½"-28 x 2%") through outer
top cabinet holes. Turn two full
turns on each screw.
[] Tighten the outer two screws to the top of the
oven. (While tightening screws, hold the oven
in place against the wall and the top cabinet.)
[_ Install grease filters. See the Owner's Hanual
packed with the oven.
21