R30 Recessed Light Extender User’s Manual Easy 1-2-3 installation
Congratulations on the purchase of the Recessed Light Extender. Once installed, you can provide directed light to specific areas around your house. Getting Started… The 45155 Recessed Light Extender model requires a “R30” size light bulb. You can use an incandescent, CFL or LED light bulb. Do not use a halogen light bulb.
4. Loosen the adjustment ring on the securing collar and slide the collar down the shaft towards the lamp hood until the collar is just above the ring line of the swivel joint. Your Recessed Light Extender is now ready to install. Installation 1. Turn the power off to the fixture. Simply unscrew the light bulb from the existing recessed can light. Insert the light bulb into the Recessed Light Extender and screw securely into place. Note: For the R30 size Recessed Light Extender, use a R30 size light bulb.
Troubleshooting - Ensure power to the Recessed Light Extender is turned “ON”. - Test your bulb in another fixture to ensure that the bulb is good. - Recessed Light Extender’s safety ratchet will begin to slip when the screw-in torque becomes too high. In this case the safety ratchet may begin to slip before the Recessed Light Extender is fully seated into the light socket, causing the Recessed Light Extender to not operate.
