Owner's Manual & Installation Instructions

8 49-5000517 Rev. 2

Configuration mode

The configuration mode is used to set the thermostat to match

the heating/cooling system. This thermostat will function with

up to 2-stage heatpump systems. To configure the thermostat,

perform the following steps:

NOTE: Operation being set will blink in the display.

1. Slide the Function switch to the OFF position.

2. Simultaneously hold the

and

buttons in

for 6 seconds while the thermostat is in OFF mode.

3. Press the

button to change settings within

each screen.

4. Press the Hold button to advance to the next screen.

Note: The Mode button will return you to the previous screen.

5. To save the changes and exit configuration mode, slide the

Function switch to Heat or Cool.

Configuration Mode Settings

The setup screens for Configuration Mode are as follows:

1. Temperature Scale (F or C)—Choose

Fahrenheit or Celsius.

Press the

button

to select.

Press the Hold button to advance to the next screen.

NOTE: Default factory setting is Fahrenheit.

2. Heat System—Check model number on the GE PTAC

chassis to determine the primary heating method.

AZ65H/95H***** are heat pumps and is the thermostat factory

setting.

AZ45E/95E***** are electric heat models and will require a

mode setting change.

To change the heating mode configuration, press the

button. Select HPb screen for heat pump or select ELE

screen for electric heat.

Press the Hold button to advance to the next screen.