Installation Guide

Prepare for LED Light Positioning
Cleaning Instructions
• If installing in the undershelf position, reinstall shelves back into case.
• Clean away any debris from case.
• Reconnect power to case.
• Gently rotate LED Light until optimal light coverage is achieved.
• Firmly tighten thumb screw to secure the LED light into nal position.
• The LED Light may be dusted as needed with a dry, clean, soft cloth.
• Do not use chemical cleaners on the system.
• Do not wipe with a soiled dishcloth or wet towel–these may leave
a residue that can damage the nish.
• Do not use scouring pads, powdered cleaning products, bleach or
cleaners containing bleach because these products can scratch
and damage the nish.
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelighting.com
1-888-69-43-533
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. Immersion is a trademark of GE Lighting Solutions, LLC. The GE brand and logo are trademarks of the General Electric Company.
66388 GE2023-2986v7
© 2014 GE 112414
7
8
This product is intended solely for the use of commercial refrigerated, display or
case lighting and is not intended for use in any other application.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This Class (A) RFLD complies with the Canadian standard ICES-003. Ce DEFR de la clase (A) est conforme a la NMB-003 du Canada.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
WARNING/AVERTISSEMENT
Risk of electrical shock. Disconnect power to LED Lights before any cleaning operation.
Risque de choc électrique. Débranchez l'alimentation des éclairages à LED avant toute opération de nettoyage.
Rotate LED Light for
optimal illumination