Installation guide

IMMERSION
TM
LED Refrigerated Display Lighting
Vertical & Horizontal Cases
68595 50W LED Drivers
GEPS6500NCMUL-SY
imagination at work
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Electrical Requirements
• The power supply must be supplied with 100-240 VAC,
50/60 Hz, and connected to an individual properly grounded
branch circuit, protected by a 15 or 20 ampere circuit
breaker or time delay fuse.
• Wiring must be 2 wire with ground and rated for 75°C (167°F).
All wiring must be done to NEC or local electrical codes.
PREPARE ELECTRICAL WIRING
WARNING/AVERTISSMENT
Risk of electrical shock. Disconnect power before servicing or installing product.
LED Retrot Kit Installation requires knowledge of luminaires electrical systems.
If not qualied, do not attempt installation. Contact a qualied electrician. Install
this kit only in the luminaires that have the construction features and dimensions
shown in the photographs and/or drawings. / Risque de choc électrique. Couper
le courant avant de réparer ou installer le produit. LED Retrot Kit d’installation
nécessite la connaissance des systèmes luminaires électriques. Si vous n’êtes
pas qualié, ne tentez pas l’installation. Contactez un électricien qualié. Installez
ce kit seulement dans les luminaires qui ont les caractéristiques de construction
et les dimensions gurant sur les photographies et / ou des dessins.
CAUTION/ATTENTION
Risk of injury. While performing installations described, gloves, safety
glasses or goggles should be worn. / Risque de blessure. Lors de l’exécution
des installations décrites, des gants, des lunettes de sécurité ou des lunettes
de protection doivent être portées.
Grounding Instructions–Cable Direct
• This lighting system must be connected to a grounded
metal, permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and be
connected to the equipment grounding terminal.
• Installation to be performed by factory trained service
personnel only.
• For use inside a commercial refrigeration case with packaged
foods only.
• Use this unit only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
• Before installing, servicing or cleaning unit, switch power off
at the service panel and follow appropriate lock out/tag out
safety procedures
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This Class [A] RFLD complies with the Canadian standard ICES-003.
Ce DEFR de la classe [A] est conforme à la NMB-003 du Canada.
NOTE: This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
FOR YOUR SAFETY
Read and observe all CAUTIONS and WARNINGS shown
throughout these instructions.
GE
Lighting
Installation Guide

Summary of content (4 pages)