- General Electric Microwave Oven Owner's Manual

....:.,............:............,.,,:

To replace hood lamp, first disconnect power at

front until it stops. Remove. Replace with same type

main fuse or circuit breaker panel or pull plug. Re-

move 2 screws from each side of lower panel and 3

screws from front edge. Lower panel until it rests on

range below. Place fingers on top near each end of

lamp. Press down and roll top of lamp gently toward

and wattage lamp. Hold lamp near each end and in-

sert prongs in sockets. Gently roll top of lamp toward

rear of range until it stops. Raise lower panel and

replace screws.

To replace your oven lamp, first disconnect power at

main fuse or circuit breaker or pull plug. Remove the

top grill by taking off 2 screws which hold it in place.

Next, remove the single screw on top left that

secures lamp housing. (On models so equipped.)

Open oven door for easier removal of the lamp hous-

ing assembly. Then grasp tab and pull out and up to

clear door hinge and front lip of oven. To remove

bulb, push it inward gently and turn to left, then pull

outward from socket. Replace with GE Lamp

# 25T8DC.

Do not attempt to operate the oven unless the grill is

place.

Clean off the grease and dust on hood surfaces

often. Use a warm detergent solution. About 1 table-

spoon of ammonia may be added to the water. Take

care not to touch the filters and enameled surfaces

with this. Ammonia will tend to darken metal.

——