Installation Instructions

8. Install Main-Breaker Lock-down

For Main Breaker Application, Lock-down kit (THQLRK3) must be installed as

shown:

Lock-Nut

Retainer-Clip for Main-

Breaker

9. Wire branch circuits

Individually wire each branch circuit wire into a circuit breaker and then firmly

plug each breaker into the interior.

Refer to label on circuit breaker for proper tightening torque. Use only General

Electric circuit breakers specified on the load center rating label. Use of other

circuit breakers or components will void the load center warranty, may void the

UL listing, and can result in property loss or personal injury.

GE Consumer & Industrial

General Electric Company

41 Woodford Ave, Plainville, CT 06062

Visit us on the web at www.GEindustrial.com

10. Remove cover KO’s

Remove only enough knockouts to match the number of circuit breakers installed.

Close all unused opened KO spaces with Knockout Filler Plates (see catalog

numbers below)

Knockout Width ½” Catalog Number: TFH

Knockout Width 1” Catalog Number: TQLFP1

11. Important

Re-tighten all electrical connections before energizing

12. Screw front on box

Simply screw on cover for both flush and surface mounting

- For Flush mounting, if the breakers do not flush up to front, loosen box

mounting screws in slotted mounting holes to allow moving the box to the proper

position as shown in schematic below. Retighten mounting screws and screw on

cover.

These instructions do not purport to cover all details or variations in equipment

not to provide for every possible contingency to be met in connection with

installation operation or maintenance. Should further information be desired or

should particular problems arise which are not covered sufficiently for the

purchaser’s purpose, the matter should be referred to the GE Company.

13. Identify circuits

For user’s convenience.

NOTE: Accessories and replacement parts are listed on the label inside the load center

door.

Place Screw-driver here and

tap with hammer

- Insert Retainer-Clip through the plastic peg after mounting the Main-Breaker.

- Add Lock-Nut over largest diameter peg.

- Push the Metal flanges of the lock-nut into the plastic to ensure proper grip.