installation instructions_and_manual

49-60745 Rev. 5 13
INSTALLING THE DOOR PANEL (Cont)
If the door swing is going to be changed please complete prior to installing the door panel. See page 11.
Depending on the door kit being installed, the door handle may need to be flipped if the door swing is being
changed. Please see instructions on page 14 on how to flip the door handle.
Attaching the Door Panel
The panel will be held on by 6 sheet metal screws and
2 machine screws.
1. Remove the gasket from the inside of the door and
retain for later use.
2. Remove any plastic covering the stainless steel
panel.
3. Place the door panel onto the outside of the door
and secure it with 2 machine screws in the left
center and right center of the door.
)DVWHQWKHSDQHOWRWKHGRRUXVLQJWKHVKHHW
metal screws. In the hinge opening area opposite
the hinge side, use the outermost screw holes only.
5. Place the covers over the hinge opening areas and
secure each cover to the door using a sheet metal
screw and washer.
6. Insert hole plug over screw installed in step 5.
7. Return the gasket to its original position.
8. Attach the door to the cabinet using the original
screws.
IMPORTANT: In some situations the door can open
too far and damage adjacent cabinets. To prevent
WKLVLQVHUWD6WRS3LQLQKDUGZDUHSDFNHWLQWRWKH
provided hole in the top and bottom hinges. Drive the
pin into the hole until the head is flush with the hinge.
9. Slide the hinge covers from the hardware packet
over each hinge.
$WWDFKWKHVLGHFRYHUVIURPWKHKDUGZDUHSDFNHW
over the hinge by peeling off the covering over the
adhesive and placing it over the side of the hinge.
Note: If the unit is being built-in a screw can be
used
to
secure the unit to the cabinet in place of installing
the side covers.
11. Return the kickplate and front service panel to
their original positions and attach to the cabinet
using the original screws.
Hinge Cover
Side Cover
Gasket
Machine
Screw
Door
Panel
8VH833(5
hole at the top
Hole Plug
Cover
8VH/2:(5
hole at the
bottom
Stop
pin
Installation Instructions
INSTALLATION INSTRUCTIONS