Installation Guide

14 49-60744-4
PLUMBING - DRAIN PUMP
Drain Installation
A drain pump is available for this ice machine. The
GUDLQSXPSNLWQXPEHULV83.DQGLVDYDLODEOHDW
GEApplianceparts.com or by calling GE
Appliances at ,Q&DQDGDYLVLW
GEAppliances.caRUFDOO
PLUMBING - GRAVITY DRAIN
Drain Installation
NOTICE
Restrictions in the drain
system to the machine will cause water to back
up into the ice storage bin and melt the ice.
Gravity drain tubing must be vented, have no
kinks, and slope to the building drain. Air gaps
are typically required by local codes.
1. Place the ice machine in front of the installation
opening. Adjust leveling legs to the approximate
KHLJKW7KHUHDUH/HJ&DSVLQWKHKDUGZDUH
packet that can snap onto the leveling legs if
they are going to show when the unit is level.
2. Insert drain tube through the routing hole in the
back panel.
3. Remove the upper back panel if needed for
access to drain connection.
NOTE: If the drain opening has been located in the
floor under the base pan according to the pre install
specifications, follow steps 4 through 7 to drain the
unit through the base. If not, proceed to step 7.
PLUMBING - GRAVITY DRAIN (cont)
4. Remove the clamp and barbed elbow and take
off the plastic cover in the base pan below the
drain hose.
&RQQHFWDVWUDLJKWEDUEHGFRQQHFWRUWR
the drain hose, securing with the supplied hose
clamp.
&XWDQSLHFHRI2'[2'W\JRQ
FOHDUSODVWLFWXELQJ6OLGHRQHHQGRIWKHWXEH
RQWRWKHFODPS/HDYHWKHRWKHUHQGRIWKHWXEH
lying on the floor of the base pan until the unit is
positioned over the floor drain.
5RXWHWKHGUDLQWXEH(LWKHUDLQVHUWWKHGUDLQ
tube through the base pan into the floor drain or
EURXWHWKHGUDLQWXEHWKURXJKWKHKROHLQWKH
lower back panel and connect to barbed elbow
and secure with clamp.
5HLQVWDOODQ\SDQHOVUHPRYHGWRFRQQHFWWKH
drain.
Water Supply
7KHUHFRPPHQGHGZDWHUVXSSO\WXELQJLV2'
FRSSHU6WDLQOHVVVWHHOIOH[RUUHLQIRUFHG3&9WXEH
may also be used. Install an easily accessible shut-
off valve between the supply and the unit. This shut-
off valve should not be installed behind the unit.
The water connection is at the back of the cabinet.
Connect using a compression fitting, one is supplied
tied to the water inlet tube at the back of the cabinet.
When built in: Coil enough tubing behind the
machine so it can be pushed into the cavity without
kinking the tubing.
Connect water supply here, fitting is
supplied in bag tied to tube.
Drain tubing
inside cabinet
Installation Instructions
INSTALLATION INSTRUCTIONS