Installation Guide

 49-60744-4
7XUQWKH:DWHU6KXW2II)ORDW9DOYHNQREWRWKH2II
position, replace the reservoir cover, and then turn
WKH:DWHU6KXW2II)ORDW9DOYHNQREEDFNWRWKH2Q
position.
14. Replace the upper back wall of the bin using the
original screws. Push in to snap bottom of back
panel into place.
3RXUDJDOORQRIKRW)ZDWHULQWRWKH
bin to flush out the drain and melt all ice that was
made during the cleaning process. Be sure all ice is
melted.
8VHDQ\OHIWRYHUVFDOHUHPRYHUVROXWLRQWRVFUXE
the scale off of the bin liner. If none is left over, use
pre-mixed or mix 1 quart according to the directions.
17. Rinse the liner with hot water.
6DQLWL]HWKHELQLQWHULRU
3XVKDQGUHOHDVHWKH212))EXWWRQWRUHVWDUWLFH
making.
The ice scoop should be washed regularly and is
dishwasher safe.
Other Maintenance
NOTE: It is normal for some lime scale to form on the gear
reducer cover. Wipe up any loose scale.
Check the top bearing.
The top bearing is non-metallic and requires no lubrication.
However, it should be checked for wear occasionally. The
top of panel must be removed to access the bearing. The
ZHDUOLPLWLVDQGFDQEHFKHFNHGZLWKDSLQJDXJH
Removing Scale from the Ice Making System (Cont.)
Winterizing
1. Clean the ice making system per the instructions on
SDJHVDQG
 2SHQWKHGRRUDQGSXVKWKH212))EXWWRQWRWXUQWKH
ice machine off.
3. Turn off the water supply.
4. Remove the back wall of the ice storage bin.
5. Remove the drain plug and drain the water reservoir
return plug to its original position.
6. Models with a drain pump installed should have about
JDOORQRI59DQWLIUHH]HSURS\OHQHJO\FROSRXUHG
into the ice storage bin drain.
NOTE: $XWRPRWLYHDQWLIUHH]HPXVW127EHXVHG
7. Turn off and unplug the machine.
Care And Cleaning (Cont.)
CARE AND CLEANING