manual
16 49-1000436 Rev. 0
Cleaning the Outside
The stainless steel door and door handle can be
cleaned with a commercially available stainless steel
FOHDQHU&OHDQHUVZLWKR[DOLFDFLGVXFKDV%DU.HHSHUV
)ULHQG6RIW&OHDQVHUZLOOUHPRYHVXUIDFHUXVWWDUQLVK
and small blemishes.
8VHRQO\DOLTXLGFOHDQVHUIUHHRIJULWDQGUXELQWKH
direction of the brush lines with a damp soft sponge. Do
not use appliance wax or polish on the stainless steel.
Cleaning the Condenser
The condenser has fins and tubes that can become
clogged with dirt and lint.
To clean:
1. Remove the kickplate and front service panel.
2./RFDWHWKHFRQGHQVHUVXUIDFH
3.9DFXXPWKHVXUIDFHWRUHPRYHDOOGXVWDQGOLQW
NOTICE
Do not dent the fins.
4. Return the kickplate and front service panel to their
RULJLQDOSRVLWLRQV)DVWHQWKHPWRWKHFDELQHWXVLQJ
the original screws.
Removing Scale from the Ice Making System
Cleaning the ice machine involves adding a solution
of scale remover and water to the ice machine and
continuing to add it as it makes ice. The scale remover
must be diluted to the correct ratio. A squirt bottle will
make adding the scale remover much easier when the
unit is built in. If not built in, remove the top panel for
reservoir access.
You should use rubber gloves when using the
scale remover. To order scale remover, go to
GEApplianceParts.comRUFDOO2UGHU
SDUWQXPEHU:;;
1. Scoop out and discard all of the ice.
2. Press and release the ON/OFF button.
3. Open door and locate screws at the upper back wall
of the bin. Remove the 2 screws.
4. Remove the back panel of the bin by lowering it
down past the scoop holder. The scoop holder will
rotate to allow the panel to lower.
:DWHUVKXWRIIIORDWYDOYHLVORFDWHGDWWKHEDFNRI
WKHUHVHUYRLU7KHYDOYH0867EHWXUQHGWRWKHOFF
position before the reservoir cover can be removed.
7XUQNQRE&&:
Condenser surface
POWER
ON/OFF
CLEAN
RESET
TIME TO
CLEAN
CHECK
WATER
ICE
MAKING
Remove screws
Reservoir cover
release tab
Care And Cleaning
Water
Shutoff
IORDW
9DOYH
VKRZQLQ
WKH2))
SRVLWLRQ
Tab to Release
CARE AND CLEANING