Installation Instructions

ManualsBrandsGE ManualsAir ConditionersAir Conditioner Cooling Area,

Table Of Contents

31-5000486 Rev. 2 13

Electrical Requirements

Model Power Supply Recommended breaker

size (A)

UUY24ZGDAA

UUY36ZGDAA

UUY48ZGDAA

UUY60ZGDAA

208/230V-1Ph-60Hz 15

Control wiring” to “Electric wiring

Using 18 Gauge Solid Core Copper Wire

1. Cut back the insulation 1” from the end of the wire.

2. Remove the screw from the terminal block, and wrap

the wire around the screw.

3. Return the screw and wire to the terminal block and

tighten securely.

Jacket / Insulation

1” (25mm)

Stranded Wire

1. Cut back the insulation 3/8” from the end of the wire.

2. Make sure the round or forked terminal connector is

rated for the amperage of the unit being installed.

3. Use a crimping tool only to fasten the connector to the

wire.

4. Return the screw and connector to the terminal block

and tighten securely.

Solderless

Terminal

3/8” (10mm)

Wiring Connections

1. High and low voltage wires should be led through

diﬀerent rubber rings of the electric box cover.

2. To avoid communication errors, maintain as much

separation as possible between the power and control

wiring.

3. High and low voltage wires should be secured

separately. Secure the former ones with large clamps

and the latter ones with small clamps.

4. Use screws to tighten high and low voltage wiring on

the terminal board. Improper connection may create a

ﬁre hazard.

5. Ground the units by connecting the ground wire.

6. All wiring must comply with local and national code.

Screw with

Special Fastener

Round

Terminal

Wire

Terminal

Board

Duct System

CAUTION

1. Ensure that the power supply is disconnected prior to

installing the heater kit.

2. A means of strain relief and conductor protection must

be provided at the supply wire entrance into cabinet.

3. Only use copper conductors.

4. Installation must follow The National Electrical Code

and other applicable codes.

5. If this appliance is installed in an enclosed area, such

as a garage or utility room with any carbon monoxide

producing appliance, ensure that area is properly

ventilated to the outside.