Installation and Operation

49-80777

CONNECT POWER

Plug power cord into properly grounded receptacle.

INSTALL FILTERS, CHECK OPERATION

• Press the ON/OFF pad on the control

to raise the vent.

• Slip fingers into the vent holes. Lift the vent

straight up and pull forward.

• Slide filter into the retainers and close the vent.

• Press the Fan Speed HIGHER pad to start the

blower. Adjust the blower by pressing HIGHER or

LOWER.

• To lower the vent, press the ON/OFF pad.

NOTE: It is not necessary to turn the fan OFF

before lowering the vent. The fan will automatically

turn off when the vent is lowered. When the fan

is not turned off before lowering the vent, it will

automatically come on at the previously set speed

when the vent is fully raised.

IMPORTANT: The vent can be activated by

pressing the pads on the switch. Do not use

excessive force or sharp objects to activate the

switch. Damage could occur and void the warranty.

Installation Instructions

INSTALLATION INSTRUCTIONS