Installation Guide

18 49-2000930 Rev. 0
Installation - UVC 9480
INSTALLATION
STEP 1
REMOVE MOTOR
ASSEMBLY FROM HOOD CANOPY
1. Remove the metal lid by removing the 3 screws
and allowing access to connectors.
2. Disconnect 2 motor cable connectors and 2
capacitor connectors.
3. Remove the 4 screws that attach the motor
assembly to the hood canopy. Save the screws
for installation.
4. Remove the motor assembly from the hood
canopy by sliding it to release it from the
mounting tabs.
STEP 2
DAMPER AND SIDE PANEL
INSTALLATION
1. Install the damper into the bottom of the exhaust
fan opening using 2 screws provided (D).
a. Check to make sure the damper opens freely.
b. Tighten the 2 screws (D).
2. Install the right and left side panels to the hood
canopy using the 4 screws (B) provided.
Screws
Metal Lid
Screws
Connectors on
Hood Side
Connectors on
Motor Side
Screws
Side Panel (1 per side)
Hood Canopy