Installation Guide

49-2000930 Rev. 0 21
STEP 5
INSTALL BLOWER MOTOR ASSEMBLY - UVC 9420 AND 9480
METHOD 2 (ALTERNATIVE)
The motors can also be installed separately to help manage the weight of the 2 motors.
1. See see Remove Motor Assembly from Hood
Canopy section to disassemble the motor assembly
from the canopy.
2. With the motor assembly out of the canopy, remove
the 4 screws from each motor. The motors are
separate from the motor plate.
3. Mount the hood into the cabinet as shown in
previous instructions. Mount the motor plate,
inserting it in the hood slots. Slide it, making sure
the 4 tabs are engaged.
4. Reinstall the 4 screws removed earlier. See
Remove Motor Assembly from Hood Canopy
section. Make sure the plate is secured firmly to the
hood canopy.
5. Lift and attach each motor using 4 screws per motor
making sure they are firmly attached to the motor
plate.
6. With both motors installed on canopy, reconnect the
4 cables of the motor to the ones on the hood side
and insert them into the protected area under the
control panel.
7. Mount the metal lid and
tighten the 3 screws to
secure the lid on the hood
body.
Slots on Hood
INSTALLATION
Installation - UVC 9420 and 9480
Motor 1
Motor 2
Screws Screws
Screws
Screws
Motor
Plate
Screws
Motor
Screws
Motor
Plate
Motor
Motor 1
Motor 2
Motor Plate
Screws
Metal Lid
Screws
Connectors on
Hood Side
Connectors on
Motor Side