Installation Guide

12 31-7000188 Rev. 0
A3. CHECK BLOWER PLATE
• Place the microwave in its upright position, with the top
of the microwave facing up.
• Check to see that the blower plate and cover plate are
correctly installed on the oven.
A4. MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use the handle or
heat shield during installation. Do not remove the
cardboard spacers between the heat shield and
door.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent cutting
of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from over tightening screws.
A4. MOUNT THE OVEN (cont)
NOTE: When mounting the oven, thread power cord
through hole in bottom of top cabinet. Keep it tight
throughout Steps 1–3. Do not pinch cord or lift oven by
pulling cord.
3. Attach the oven to the top cabinet by inserting
2 self-aligning screws through outer top cabinet holes.
Turn two full turns on each screw. Be sure to keep
power cord tight. Be careful not to pinch the cord,
especially when mounting flush to bottom of
cabinet.
Installation Instructions
2. INSTALLATION TYPES (Choose A, B or C)
Blower Plate
Cover Plate
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Oven Top
Equivalent to
Depth of Cabinet
Recess
Self-Aligning Screw
2. Rotate front of oven up
against cabinet bottom.
1. Lift oven, tilt it forward
and hook slots at back
bottom edge onto two
lower tabs of mounting
plate.