Installation Guide

31-7000188 Rev. 0 15
B2. USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws, a hole
large enough for the power cord to fit through, and a
cutout large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
•
Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION
Wear safety goggles when drilling
holes in the cabinet bottom.
B3. ADAPTING MICROWAVE AIR
DIRECTOR FOR OUTSIDE TOP
EXHAUST
1. Remove the screw that holds the blower plate to the
microwave. Remove the cover plate.
2.
Carefully pull out the AIR DIRECTOR.
3. Rotate the air director counterclockwise 180°.
4. Place the air director back into the opening.
5. Replace blower plate with the screw removed in
Step 1. Make sure the screw is tight.
Installation Instructions
A
C
D
B
2. INSTALLATION TYPES (Choose A, B or C)
Cover Plate
Blower Plate
Back of
Microwave
Air Director
Before:
Openings Facing
Forward
Before Rotation After Rotation
After: Air Director
Openings Facing Back
Back of
Microwave