Installation Guide

16 31-7000188 Rev. 0
Installation Instructions
2. INSTALLATION TYPES (Choose A, B or C)
B3. ADAPTING MICROWAVE AIR
DIRECTOR FOR OUTSIDE TOP
EXHAUST (cont)
6. Attach the exhaust adaptor to the top of the blower
plate by sliding it into the guides of the blower plate.
7. Push in securely until it is in the locking tabs. Take
care to ensure that the damper hinge is installed so
that the damper swings freely.
B4. CHECK FOR PROPER DAMPER
OPERATION
• Make sure tape securing the damper is removed and
damper pivots easily before mounting microwave.
• You will need to make adjustments to ensure proper
alignment with your house exhaust duct after the
microwave is installed.
B5. MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use the handle or
heat shield during installation. Do not remove the
cardboard spacers between the heat shield and
door.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from over tightening screws.
NOTE: When mounting the microwave, thread power
cord through hole in bottom of top cabinet. Keep it
tight throughout Steps 1–3. Do not pinch cord or lift
microwave oven by pulling cord.
1
. Lift microwave, tilt it forward, and hook slots at back
bottom edge onto four lower tabs of mounting plate.
2
. Rotate front of microwave oven up against cabinet
bottom.
Adaptor
Guide
Locking Tab
Back of
Microwave
Damper
Exhaust Adaptor
Blower Plate
Back of
Microwave
Power Cord