Installation Guide

20 31-7000188 Rev. 0
Installation Instructions
2. INSTALLATION TYPES (Choose A, B or C)
C5. ADAPTING MICROWAVE AIR DIRECTOR
FOR OUTSIDE BACK EXHAUST
4. Place the air director back into the opening.
5. Secure the blower plate to the microwave with the
original screw.
6.
Attach the exhaust adaptor to the rear of the oven by
sliding it into the guides at the top of the center of the
back of the oven.
7.
Push in securely until it is in the lower locking tabs.
Take care to ensure that the damper hinge is installed
so that it is at the top and that the damper swings
freely.
C6. MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use the handle or
heat shield during installation. Do not remove the
cardboard spacers between the heat shield and
door.
NOTE: If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the
cord.
NOTE: We recommend using filler blocks if the cabinet
front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from over tightening screws.
NOTE: When mounting the microwave, thread power
cord through hole in bottom of top cabinet. Keep it
tight throughout Steps 1–3. Do not pinch cord or lift
microwave oven by pulling cord.
1. Lift microwave, tilt it forward, and hook slots at back
bottom edge onto four lower tabs of mounting plate.
2. Rotate front of microwave oven up against cabinet
bottom.
After: Air Director
Openings Facing Back
Blower Plate
Cover Plate
Back of
Microwave
Adaptor
Guide
Locking Tabs
Guide
Back of
Microwave
Power Cord