Installation Guide

31-7000188 Rev. 0 5
Installation Instructions
TOOLS YOU WILL NEED
#1 and #2
Phillips
screwdriver
Pencil
Ruler or tape measure and
straight edge
Carpenter square
(optional)
Tin snips (for cutting
damper, if required)
Electric drill with
3
⁄16″,
7
⁄16″,
1
⁄2″and
5
⁄8″drillbits
Hammer (optional)
Stud
finder
Filler blocks or scrap
wood pieces, if needed
for top cabinet spacing
(used on recessed
bottom cabinet
installations only)
Gloves
Saw (saber, hole or keyhole)
Level
Duct and masking
tape
Scissors (to cut
template, if necessary)
Safety goggles
MOUNTING SPACE
NOTES:
•Thespacebetweenthecabinetsmustbe30″wide
and free of obstructions.
• If you are going to vent your oven to the outside, see
Hood Exhaust Section for exhaust duct preparation.
• When installing the oven beneath smooth, flat
cabinets, be careful to follow the instructions on the
top cabinet template for power cord clearance.
• * If the cabinet depth, including cabinet doors, is
more than the maximum dimension shown, then
the oven must be spaced out from the wall using
adequate materials supporting 150 lbs to allow
proper top vent air exhaust/intake.
• For models with top venting holes: Do not allow
cabinetry or other objects to block the airflow of the vent.
• All other over-the-range microwaves should not be
installed over any cooktop or range with a combined
BTU greater than 63,000 BTU.
30″
30″
min.
*13-3/4″max.
66″
min.
10-1/4”