Installation Guide

31-7000188 Rev. 0 7
B. FINDING THE WALL STUDS
1. Find the studs, using one of the following methods:
A. Stud finder – a magnetic device which locates
nails.
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound. This will
indicate a stud location.
2. After locating the stud(s), find the center by
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be16″(40.6cm)or24″(61cm)fromthismark.
3. Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
1. PLACEMENT OF THE MOUNTING PLATE
Wall
Studs
Center
Installation Instructions
A. REMOVING THE MICROWAVE
OVEN FROM THE CARTON
1. Remove the Installation Instructions, exhaust
adapter, turntable ring, filters, glass tray, and the
small hardware bag. Do not remove the foam
protecting the top of the oven.
NOTE: Do Not Remove the plastic plug protective
cover until just before hanging the oven.
Keep the oven at least 8 inches away from the
countertop edge to prevent dropping due to the
heavy door.
2. Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in the
foam.
3. Pull the carton up and off the oven.
4. Set the oven upright. Remove and properly discard
plastic bags and foam packing.
5. Cut the middle of the outer protective plastic bag to
remove the mounting plate.
A. REMOVING THE MICROWAVE
OVEN FROM THE CARTON
6. Remove the screws from each end of the mounting
plate. This plate will be used as the rear wall
template and for mounting. Reinstall the screws
into the holes from where they were removed.
Carton
foam
Exhaust Adapter
Glass Tray
Small Hardware Bag
Filters and Turntable
Ring below glass tray
Screws
Screws
Mounting Plate