Installation Guide

8 31-7000188 Rev. 0
C. DETERMINING MOUNTING PLATE LOCATION UNDER YOUR CABINET
Your cabinets may have decorative trim that interferes
with the microwave installation. Remove the decorative
trim to install the microwave properly and to make it
level.
THE MICROWAVE MUST BE LEVEL
Use a level to make sure the cabinet bottom is level.
If the cabinets have a front overhang only, with no back
or side frame, install the mounting plate down the same
distance as the front overhang depth. This will keep the
microwave level.
1. Measure the inside depth of the front overhang.
2. Draw a horizontal line on the back wall an equal
distance below the cabinet bottom as the inside depth
of the front overhang.
3. For this type of installation with front overhang only,
align the Rearwall Template with this horizontal line,
not touching the cabinet bottom as described in
Step D.
Installation Instructions
Plate Position –
beneath flat bottom cabinet
Draw a vertical line on the wall at the center of the
30” wide space. Tape the Rear Wall Template onto
the wall matching the centerline and touching the
bottom of the cabinet.
Plate Position – beneath framed
recessed cabinet bottom
Draw a vertical line on the wall at the center of
the 30” space. Tape the Rear Wall Template onto
the wall matching the centerline and touching the
bottom cabinet frame.
30” to Cooktop
Plate Position – beneath recessed
bottom cabinet with front overhang
30” to Cooktop
Draw a line on the
back wall equal to
the depth of the front
overhang
1. PLACEMENT OF THE MOUNTING PLATE
1/4”
Minimum
Clearance
1/4”
Minimum
Clearance
10-1/4”