Instruction Sheet to Replace Thin Twin Tub Kit Contains: Tools Leaded: 1 fond Post Gasket 8146” Nut Driver 1 Cantor Past Gasket &/18” Socket and Wrench Ethical Shock Hazard 1 Instruction Sheet 7146 Socket and extension Disconnect power before servicing. sate shipment Phillips Screw Driver ul i: i Replace all parts and panels before 4 ue Hoodie Hose Pliers operating. Sleeves Spanner nut Wrench Failure to 40 so can result in death Safety Glasses Hammer or electrical shock.
&. Remove the agitator cap, barrier cap and 7/16" bolt. Bee Figure 7. $. Unsnap and remove the tub ring, Lay over side panel, Ses Figure 8 WI0811357 A 1. Unanswered ground wire. See Figure 10 FIGURE 10 12. Remove the two lower plate bolts See Figure 77. RUPTURE 13. Unplug the Pressure Hose and remove from the tub. See Figure 12. FIGURE 12 14. Slide the base assembly out as shown in the picture. Bee Figure 13.
15. Remove Basket and Drive Block. See Figure 14. 16. Remove Drain Hose: Remove the upper clamp and slide the hose off of the tub port. See Figure 15. FISSURE 15 17. Remove counterbalance spring located towards the Tear of the tub. See Figure 18 HEIRESS 18. Remove the six (5) tub screws, See Figure 77. FIGURE? 19. Use dish soap or rinse aid on pew center post gasket to help insert into the new tub assembly. Ensure that the center post gasket is inserted correctly as shown in the picture below.