Installation guide

Installation Preparation
MATERIALS YOU WILL NEED:
Materials Required for All Installations
[] 90° Elbow (3/8"NPTexternal thread on one end, opposite
end sizedto fit water supply)
Note: Usenew ferrule. Do not use old parts.
[] Strain relief for electrical connection
[] Thread seal tape
[] UL Listedwire connectors (3)
[] Screwtype hose clamps
Materials For New Installations Only:
[] Air gapfor drain hose, if required
[] Waste tee for house plumbing, if applicable
[] Electrical cable or power cord, if applicable
[] Hand shut-off valve (recommended)
[] Water line 3/8" min. copper or 1/2" min. plastic (plastic
must betested for temperature and pressure)
[] Couplerfor extending drain line, if applicable
@
90° Elbow
ThreadSeal
Tape
©G
Screw Type Clamps
WireNuts
Shut-Off
WasteTee Valve
Air c°uO_pler
Gap
©
StrainRelief
ElectricalCable
or PowerCord
HotWater Line
TOOLS YOU WILL NEED:
FlatBladeScrewdriver
Nut Driver
Tools Required for All Installations
[] Phillips head and flat blade screwdrivers
[] 3/8", 5/16" and 1/4" nutdrivers
[] Level
[] Carpenters square
[] Measuring tape
[] Safety glasses WireStrippers
[] Flashlight
[] Bucket to catch water when flushing the line
[] Tubing cutter
[] Glovesto protect against sharp edges
[] Wire strippers
For New Installations Only:
_ PhillipsHead
_z_, Screwdriver
SafetyGlasses _ ,4._,_,,_ _E_ _Uubtit_
+
[] Drill and appropriate bits
[] Hole saw set
Gloves
Level
Square
Hole
SawSet