Installation guide
Installation Preparation
PREPARE HOT WATER LINE
The line may enter fl'om either side, rear or floor
within the shaded area shown.
• The water line may pass through the same hole as
the electrical cable and drain hose. Or, cut an
additional l-1/2" dia. hole to admit the line. If a
power cord with plug is used, it must pass through
a separate hole.
Water Line Connection
• Turn o11 the water supply.
• Install a hand shut-otI valve in an accessible loca-
tion, such as under the sink. (Optional, but strongly
recommended and may be required bv local codes.)
• The hot water line should be 3/8" O.D. copper
tubing or 1/2" O.D. plastic tubing. The line must
extend forward at least 30" fl'om the left side or 40"
fi'om the i'eai" wall.
• The water line illtlSt be hmg enough to form a
smooth natural loop with no sharp bends or kinks
between the cutout entry.
/
/
i\
i \
\
Shut-offValve
\
,,_
ii
ii
Hot[]::::
ii
ii
ii
CabinetFace_
fromWall 2" fromFloor
• At!just water heater to deliver temperatures of 120°F to
150°F.
• lqush watei" line to clean out debris.
• The hot water supply line pressure must be 90-190 PSI.