Installation guide

Installation Preparation
PARTS SUPPLIED:
Remove the hardware accessory bag and other parts
fl'om inside or taped to the outside of the dishwasher.
Check contents against illustrations to iilsure that all
parts are included,
[] 2-piece toekick
[] 6 screws (see illustration)
[] 2 leveling legs
[] Templatefor the installation of a
custom panel packed with models
ZBD7000and ZBD7005only
[] Junction box cover
Screws A Screws B
(2) Countertop (2) Cabinet
Mounting Mounting
Screws Screws
Junction
BoxCover
with screws
Screws C
(2)Color
Matched
Toekick
Screws
2 Leveling Legs
I
Template I
for
ZBBTO00_ '1
ZBDT005
Oily
Template with Mounting Hardware
2-PieceToekickwith
SoundInsulation
PREPARE DISHWASHER ENCLOSURE
34"to35"
Underside
ofCountertop
to Floor
24-1/4"Max
*Models ZBD7000and ZBD7005 with custom panels are 24-3/4"deep
• The rough cabinet opening i/ltlSt be at least 24" deep,
23-7/8"rain, to 24-1/4" wide. The height should be 34"
rain. and 35" max.
Note: ADA installation, beneath 34" high countertops may be accom-
plished by removing front leveling legs. Drain hose, water and
electrical must be routed through the cutout onthe back of the
dishwasher.
• The dishwasher must be installed so that drain hose is
no more than 10 feet in length for proper drainage.
• The dishwasher must be flfllv enclosed on the top, sides
and back, but should not support any part of the
enclosure,
• The floor inside the opening must be even and level
with the finished floor of the kitchen, If the kitchen
floor is tile, it may be
higher than the floor of
the installation cutout,
Pieces of wood may be
placed into the cutout
floor to make it level or
higher than the room
floor, This will alh)w easy
removal fi)r any flmu'e
service,
CornerInstallation
• When installing into a
corner, allow 2" rain.
clearance between
dishwasher and adjacent
cabinet or wall.
• Allow 24-1/8"min.
clearance from the front
of the dishwasher for door
opening.
Countertop
5