Installation guide

Custom Panel Dimensions
CUSTOM PANEL FOR MODELS
ZBD6400 ONLY
Panel kits must be ordered separately. Installation
of any custom panel should be completed before
the dishwasher is installed.
1/4" PANEL WITH ZPF625 TRIM KIT
1/4"Thick
DoorPanel
23-1/8"
25-5/16"
• Cut the panel to the dimensions shown.
• The bottom left and right coi'nei's should be ctlt at
1/4" radius. See illustration.
3/4" PANEL WITH ZPF675 TRIM KIT
The custon_ panel size xaries depending on your
ii]stallation.
Countertop Custom
Panel Size
Cabinets
A
F Floor _.11_
/ Bottomof 3/4"Max.
AdjacentCabinetry
Top
3/4" Thick _He ght
Door Panel
23-1/8"_
Height is equal to A minus 5-1/4" plus 1/4"
EXAMPLE: A = 30-1/2" minus 5-1/4", plus 1/4" is equal to 25-1/2".
1. Measure Dimension A, fl'om underside of countertop
to bottom of ac!jacent cabinets.
2. Subtract 5-1/4". Control panel height is 5". Allow
1/4" clearance between countertop and control
panel.
3. Add 1/4". The CtlStOlll panel slides up, behind
control panel.
CUSTOM PANEL FOR MODELS
ZBD7000 AND ZBD7005
These models require a field installed 3/4" thick custom
panel and CtlStOlll handle. An installation template is
packed with these models and may be obtained in
advance. Order Pub. No. 49-5919. See page 15 for panel
installation instructions.
c_bi_tsII1
f ! Floor
/ Bottomof
Custom
Pane]Size
_11_
3/4" Max.
Adjacent Cabinetry
\
B
STEP A: Determine custom panel height
1. Measure dimension A, fl'om the underside of the
countertop to the bottom of a(!jacent cabinets.
2. Subtract 1/4". This allows a 1/4" clearance gap
between the underside of the cotmtertop and the top
of the dishwasher door.
HEIGHT A- 1/4"
Note:26-1/4"minimum panel height is required to cover the door
frame. Panel height varies depending on installation. Consideration
must be givento door swing clearance abovethe toekick.
STEP B: Determine custom panel width
1. Measure dimension B, the rough opening width.
2. Subtract 1/4" for clearance (1/8" on each side).
WIDTH B-l/4"
Note:23-1/8"minimum panel width is required to cover the door
frame.
Toekick Installation
These dishwashers are supplied with a standard toekick.
However, a notched continuous toekick is recommended
to prevent door swing interference and to maintain
toekick aligmn ent with a(!jacent cabinets. See page 14
for details.
ADA Installations Beneath 34" Countertops
Use the same methods shown here to calculate door
panel height. A notched ('oI_tiI_tlOtlS toekick will help to
prevent door swing interference and maintain toekick
aligmnent with a(!jacent cabinets.