Manual

Water Fill
Level
For best i)e_timnance, check the x_ater fill lexel of}our
Chef's _sher
Once tile Chef's }\_sher is flllly connected, run it through
a complete RINSE ONIN (on some models) cycle to
ensure it is emptying and filling correctl> For low water
pressure situations, mn tile RINSE ONIN (on some
models) cycle 3 times, Halflvay through the final RINSE
ONLY (on some models) cycle, pause the Chef's h_sher
and check the water level inside the Chef's _'\hshet; If the
water level is not above tile minimum water level (marked
on tile lower spray support tower), increase tile fill level,
1, Ensure tile Chef's X_'asher is not _unning through a
cycle. Depress the _;kTER TEMP button fin" ten
seconds until the second buzzer sounds.
2. Press tile START/CANCEI, button to select fill time,
as per chart (65 seconds is the tactory setting).
3. To test time, press DEI,AY START. The Chef's Washer
will start filling, i,isten fin" the Chef's Washer to
complete filling. Once filled, the fill level must be
checked to ensure fill time is correct.
4. Once complete, press tile X4__TER TEMP button to
exit fill time mode.
Maximum_m level
Continue to press tile
STAI),T/CANCEI, button until tile
desired indicator is illuminated.
Cycle Status
Indicators
SENSING
X&;__SHING
RINSING
DRYING
CI,EAN
Fill time
55 seconds
60 seconds
65 seconds
t:) seconds
85 seconds
21