Manual

Operation - ZBD6605
(t._/'s /l?_sker
Start a
wash load
To start the Chef's Washer, close the door until it locks in place. To start the last selected cycles,
press the START button. To select a different cycle, turn the knobs to the desired WASH CY(:I,E
and HEAT OPTIONS and press the START button.
NOTE: Not all heat options axe available for all cycles. If a combination that is not available is
selected, the lights will flash when the START button is pressed, and the cycle will not start.
X_ash Cxcles
HEAVY DUTY
NORMAI, WASH
I,IGHT X£__SH
SPEED WASH
RINSE ONI,Y
./
./
./
HEAT OPTIONS
NOP.MAI. HIGH SANITIZE
& HEAT HIGH TEMP & (includes
DRY TEMP HEAT DRY HEAT DRY)
,/
,/
,/
,/
,/
To interrupt/pause a cycle, gently open the door just enough to turn off the wash motor. Do not
flflly open the door tmtil the wash action ceases.
CAUTION: Be careflfl when opening the door; the hot steam that escapes when the door is
opened may cause ii_jm'ies. Stand back as you open the door and allow the steam
to escape.
_ATTENT1ON : Faites attention lorsque xous omrez la porte, i,a xapeur brfllante qui
s'&'hapI)e lorsque vous ouvrez la porte pendant tm programme de lavage peut
causer des brfllm'es. I,orsque vous ouvrez la porte, reculez et laissez la vapem"
s'0chai)per de l'appareil.
To restart the wash process, close the door tmtil it locks in place. There may be a time delay of
up to a ti_w minutes because the temperature inside your Chef's _,Vasher needs to stabilize betore
it restarts the wash cvcle.
To cm_cel the cycle after it has started, press and hold the START/CANCEI, button for 3 seconds.
The Chef's _hsher will start to drain and the cwle indicator lights will flash. At this point a new
wash cycle can be selected. If a new cycle is not selected, all the Cycle Indicator lights will go out
after the Chef's _'asher drains completely. If you have selected a new wash cycle, remember to
add more detergent to the detergent compartment if required.