Manual

Bulk Dispense Detergent Dispenser
Dishwasher
Water
Hardness
Calibration
Prior to the first use, the dishwasher needs
to be calibrated for water hardness. Please follow
the directions below to calibrate the dishwasher
to the hardness of your tap water.
Determine the Hardness of Your Tap Water
In the bag that contained these instructions, you
should find a water hardness test strip package.
Read the instructions on the package, remove
the test strip and follow the instructions to
determine the hardness level of your tap water.
You will use this information to calibrate your
dishwasher to dispense the optimal amount
of detergent.
Water hardness test strip indication
SOFT
HARD
Value to Enter
into Dishwasher
0 RED _ 1
1 RED _ 2
2 RED _ 3
3 RED _ 4
4 RED _ 5
Calibration of Models With 3-Digit Display
Display Pressat the same time.
.
.
3.
.
Open the door and touch a pad
(other than START/RESET)to turn the lights on.
Pressthe"Up" _ ArrowPad and DELAY
HOURS pad atthesame timefor3 seconds.
The displaywillshow a number from 1to S.
Thisisthewaterhardnessvaluecurrentlyset.
Press the "Up" _ Arrow Pad to raise
the value or the "Down" _Arrow Pad
to lower the value. Set the water hardness
value to the number determined with
the test strip and table above.
Once the water hardness is set, press
the START/RESETpad to save the setting
and return the dishwasher to normal
operation.
Calibration of ModelsWithout 3-Digit Display
1. Openthe door and touch a pad to turn lights on.
2. Pressthe "Up" _ arrow pad and DELAYHOURS
pad at the same time for 3 seconds.All lights
will light up and you will hear I to 5 beeps.The
number of beeps indicates the current hardness
value.
3. To change the setting, pressthe DELAYHOURS
pad the number of times that corresponds to the
water hardnessvalue determined at the left. The
control will beep each time you pressthe pad.
4. Once finished pressing the pad, you will hear a
confirmation with beepsfor the number of times
you pressedthe pad.
5. If the number of beeps is not what you desire,
start pressingthe DELAYHOURSpad again to
reenter a new water hardness level.
6. Once the water hardness is set, pressthe
START/RESETpad to save the setting and return
the dishwasher to normal operation.
NOTE:Youshould recalibrate the dishwasher control
if water conditions change; for example, if a water
softener system is added or removed from your
home.
12