Installation Instructions If you have questions, ca!l 800.626,2000 or visit our website at: ww.monogram.
Safety Information BEFORE YOU BEGIN: WARNINGS: Read • Use this appliance only for its intended purpose. • Immediately repair or replace electrical service cords that become frayed or damaged. • lJnI)lug the trait befl)re cleaning or making rei)airs. • Rel)airs should be inade by a qualified service technician. these instructions completely IMPORTANT for local inspector's and Note to Installer - S_,,e_heseinst,uctions xour - Obse,,e _,ll_.,eH_ing ordinances. instructions Note carefully.
Design Guide THE INSTALLATION SPACE PRODUCT CLEARANCES The wine chiller, wine reserve and be_era-e center is lhctor_ set for a l l 0 ° door When installed swing. in a corner: • Allow 4" rain. clearance on the hinge side fl)r the 90 ° door swing and to allow racks to slide out. • Allow 10" minimum clearance on the hinge side fi)r a filll 110 ° door swing.
Installation Instructions TOOLS REQUIRED STAINING WOOD DRAWER FRONTS • #2 Phillips • A(!i ustable The screwdrixer wrellch drawer fronts are unfinished cherry wood. Dm'ing use, oil fl'om hands may accmnulate and stain the wood. • The drawer fronts may be stained and sealed to PARTS SUPPLIED match • Monogran/ namei)late • Hardware for changing door swing • Optional stainless steel toekick with screws and spacers • I,elt and right side hinge covers • Top screw hole cover a(!jacent cabinetry.
Installation Instructions ISTEP 21 REVERSE DOOR SWING SKIP THIS STEP IF DOOR SWING SUITS THE INSTALLATION Install 3 Hinge _i Screws i Parts Included: • • • • • Top left case hinge Bottom lefi case hinge I,eft and right side decorative Decorative hinge screw hole Torx ® driver bit Remove TopHinge hinge cover cover Hinge Pin and Bracket Tools Required: • Phillips • Electric screwdriver drill Remove the door: • Flatten • Remove tile shipi)ing the 2 screws screws • Use and the supplied remove I,
Installation Instructions ISTEP 31 LEVEL • Use and • an a(!justable wrench raise the or lower A@lst careflllly; phunb with toekick the cabinetr> to turn the leveling ISTEP 51 SLIDE PRODUCT THE CUTOUT legs product. product and • Carefully, should should be level align with and slide Be careful a@_cent • Make height, the not the certain that surrounding • Check again unit into to entangle the the power door INTO opening. cord.
TEMPLATE FOR NAMEPLATE LOCATION Cut on Dotted Line "]_)" Upper Left '_ Top of Glass Door Cornerof Glassif Hinge is on Left Topof Badge_ Monogram. Upper Right Cornerof Glassif Hinge is on Right £ J ',4 DoorFrameSide 11_', DoorFrameSide DOORNAMEPLATELOCATION To position • Cut nameplate: template • Hold or tape along glass door so that the fl'ont side. • Remove backing • Place door, dotted template nameplate matching line. behind it is visible fi'om from nameplate.