Installation guide

Safety Information
BEFORE YOU BEGIN:
Read these instructions completely and carefully,
IMPORTANT - S_,,e_heseinst,uctions
for local inspector's use.
IMPORTANT - Obse,,e_,ll_.,eH_ing
codes and ordinances.
Note to Installer - Be sure to leaxe these
instructions with the Consumer.
Note to Consumer - Keep these instructions with
xour (-)wner's Manual for flmue reference.
WARNING - his li ,n ere.stbe
properly gmtmded. See "(;rom_dinf', page 4.
AVERTISSEMENT -
Cet appareil &fit _tre correctement raise _'l la terre.
Consulter <<Mise _'l la terre>>, page 4.
lf)ou recei',ed a damaged wine reserxe or beverage
center, you should immediately contact your dealer
or builder.
Skill Level - Installation requires basic mechanical
skills. Proper installation is the responsibility of the
installer. Product taihu'e due to improper installation
is not covered trader the GE Appliance _\'arrantv.
WARNINGS:
• Use this appliance only for its intended pm])ose.
• Immediately repair or replace electrical service
cords that become frayed or damaged.
• Uni_lug the trait heft)re cleaning or making repairs.
• ]_epairs should be made by a qualified service
technician.
AVERTISSEMENT :
• ll ne taut utiliser cet appareil que pour l'usage
pore" lequel il a _t_ construit.
• I1 taut r_parer ou remplacer imm&liatement tout
cordon d'alimentation _lectrique efliloch_ ou
endommag¢:.
• D_brancher le bar ou le r_fl'ig_rateur a vin a\m_t
le nettoyage ou route intervention.
• I,es r_i_arations doivent _tre taites par tm
technicien qualifi_.
For Monogrmn local service in your area, call
1.800.444.1845
For Monogrmn service in Canada, call
1.888.880.3030
For Monogram Parts m_d Accessories, call
1.800.626.2002.
_v. monogram.coin
CONTENTS
DesignGuide
The Installation Space ............................3
Product Clearances ................................3
InstallationInstructions
Tools,Hardware .......................................4
Groundingthe Product ...........................4
Staining Wood Drawer Fronts ...............4
Step 1, RemovePackaging ....................4
Step 2, Leveling........................................5
Step 3, Connect Power ...........................5
Step 4, Slide Product into Cutout..........5
Step 5, Changethe Toekick....................5
Step 6, Set Temperature Controls .........5
2