Installation guide

Installation Instructions
ISTEP 21 LEVEL
• Use an a(!justable wrench to turn the leveling legs
and raise or lower the product.
• A@lst careflllly; the product should be level and
I)lumb with cabinetr> and should align with a@_cent
toekick height,
Turn Right to Lower
Turn Left to Raise
ISTEP 31 CONNECT POWER
• Connect power cord plug to a properly grotmded
receptacle.
• Check to make sure power is on by opening the door
to see if interior light turns on.
ISTEP 41 SLIDE PRODUCT INTO
THE CUTOUT
WARNING: D,,n,,t i,,ess .e,,,
push against the glass door when moxing or installing
these products. Pressm'e against the glass door will
ca use damage.
AVERTISSEMENT : ep,) ,sse
jamais et ne mettezjamais de pression sur la porte
en verre quand vous d_placez ou installez ces
produits. Toute pression sur le verre occasionnera
des dolnlnages.
• Carefiflly slide the trait into the opening.
Be careflfl not to entangle power cord.
• Make certain that the door protrudes l" bewmd
the surrotmding cabinets.
• Check again to be sure the trait is level.
ISTEP 51 CHANGE THE TOEKICK
• The stainless steel toekick is secm'ed to the back
of the product or inside.
• The toekick has a
cutout on the left
and right
sides.
Rein ove
the plug
on the
left side MoveFill
Plugto
and RightSide
reinstall
on the
right side. If "_
VO/I choose to
install the stainless
steel toekick, reinstall the plug on the right side
of that toekick.
• Install original screws and spacers or screws and
spacers supplied with the stainless steel toekick,
Install screws through the spacer standott, toekick
and into the base as shown.
ISTEP 61 SET TEMPERATURE
CONTROLS
• The temperatm'e controls are preset. Refer to
the Owner's Manual for more information.
Allow 24 horn's for temperatm'e to stabilize.
5